Receiver

Link M

Technologies Where losing it doesn't mean you're out of control! ™

Los Controles Receiver

Click on picture for larger image Use the browser "Back" to return

How it's made:

The heart of the specially designed and built remote control decoder is housed in an extruded aluminum enclosure and uses a FCC Type accepted 900MHz FM receiver for improved range and noise immunity.
This system does not use relays that will eventually stick and blow out your high priced pumps, but instead utilizes eight solid state, high power, fused output controllers configured to drive up to a four pump, four dump hydraulic system.
Its command decoder is protected from foreign control with a 1 billion possible rolling code that changes its own combination every time it receives a command from its transmitter. So even if someone were to capture your signal and try to use it, too bad! It's old news because the receiver will ignore it.

What it does:

All pump functions are pulsed, meaning that no matter how long the pump switch is held, the pump is only "ON" for a fraction of a second, saving the pumps from accidental over driving.
Independent timing controls for pump and dump outputs allow custom "pulse time" tuning for your particular hydraulic system because not all systems are built alike. A large battery bank would use a shorter pulse time to lift the ride because of the high speed pumping where a smaller battery bank would need a longer pulse time due to the slower pump speed. The pump timing control can be used to set the number of pumps it takes to lift the car before hitting critical height.
Programmed with all the popular moves and poses along with Link M Technologies' unique "One Touch" hop function that produces a dump/pump output with one flip of the switch, effectively cutting switch flipping in half.
A single remote transmitter will control more than one car at a time with this receiver in them once the choreographic mode is activated. Hit the function "♠" switch to the right and they all drop. Hit the function "♠" switch to the left and they all go up. Hit the "♦" switch to the left, while in Mode "A", and they all pose with a three wheel attitude. Make them all move together for a spectacular show of machinery control!

How it's done:

Initially, only one remote control is programmed into all four memory locations of the receiver, making it the only one with access to it. But when you'd like to make all of your clubs' cars move together:
- Press the PROGRAM switch on each of the receivers and it will light up solid.
- Then hit any of the switches on only one of the remote controls. The receivers' PROGRAM switch begins to blink showing that it has recognized that remote control.
- Turn off the program mode by pressing the PROGRAM switch again on all the receivers and they are all ready to be controlled by that one remote control.
That single remote transmitter can control any number of cars within range that have been upgraded with this system now that it has been given a memory slot within the receiver.
After the show is over, the owner can restore the receiver to "single user only" by repeating the PROGRAM function with his own remote control four times to take up all the memory slots again.